To Start The Product; To Apply And Release The Parking Brake; To Start The Product For The First Time - Husqvarna P 535HX Manual De Usuario

• To adjust the armrests up and down, turn the
adjustment screw.

To apply and release the parking brake

1. To apply the parking brake, pull the parking brake
lever fully rearward into the parking brake holder.
2. To release the parking brake, move the parking
brake lever fully forward.

To start the product for the first time

To start the product for the first time, you must first
install the servicing plug and the main switch.
1. Get the servicing plug and the main switch from the
plastic bag at the steering wheel.
2. Install the servicing plug. Refer to
install the servicing plug on page 46 .
3. Install the main switch. Refer to
page 3 and To start the product on page 33 .
1591 - 001 - 21.12.2020
To remove and
Product overview on

To start the product

1. Push down and turn the main switch to the ON
position.
2. Turn the power key to the ON position. Wait until the
symbols and gauges show on the display.
Note:
The product is on but does not move if you
push the forward or rearward pedals.
Note:
The product is on for 3 minutes. To operate
the product after 3 minutes, turn the power key
again.
3. Push the start button for the electrical drive (A). The
motor for the hydraulic system starts and then stops
again.
A
B
33