Baxi CBP Matic 18 Manual De Instrucciones página 199

8. Start-up
To start up the pellet-run boiler, press the start/stop button for 3 seconds. The display
should indicate "Acendimento" (Lighting) until this completion of this phase.
The pellets will be pushed through the supply channel into the burning basket
(combustion chamber), where they will be ignited using a heater coil. This process
may take between 10 and 15 minutes, depending on whether the pellet transport
worm screw has been previously loaded with fuel or is empty. Upon completion of the
ignition phase, the word "On" should appear on the display.
8.1. Stoppage
The unit stop sequence is activated by pressing the "On/Off" key for 3 s. The display
shows the "desactivação" (deactivation) message until this phase is completed. The
extractor will remain active until the fume temperature reaches 59 ºC.
8.2. Turn off the unit
The unit should only be disconnected after stoppage.
Make sure that the display indicates "Off". If necessary, disconnect the power cable
from the mains.
8.3. Instructions for removing the side covers
8.3.1. Remove side covers
Lift the cover, pulling up and forward, thus removing it from the upper and frontal
slots. Do the opposite to assemble the unit.
36