ELICA diamond 604 Montaje Y Modo De Empleo página 20

Assembly
Before starting the installation:
• After unpacking the product, check that it was not
damaged during transport and in case of problems,
contact your dealer or Customer Service, before
proceeding with the installation.
• Check that the product is of the right size for the
installation location.
• Check for accessories inside the packaging (placed there
for ease of transport) such as bags containing screws,
the warranty card, etc. Remove them and keep them
safe.
• Also verify that near the area of installation there is an
electrical socket
Preparing the cabinet for installation:
- As the bottom of the product must not be accessible after
installation, a separator panel must always be installed
(for protection) under the hob (not supplied with the
product), if it is accessible after installation.
- If installing an oven under the top, do not interpose the
separator panel.
- If an oven is positioned under the induction hob it is
preferable that it is equipped with a cooling fan.
- Do not use the induction hob while the PYROLYTIC
cleaning of the oven is in operation.
- Avoid installing the hob above dishwashers or washing
machines so that the electronic circuits do not come into
contact with steam and moisture which could damage
them.
- The distance between the bottom of the device and the
partition panel (or any device installed below the induction
hob) must comply with the sizes indicated.
- To correctly operate the product, do not obstruct the
minimum opening between the worktop and the upper
side of the cabinet top.
- For adequate ventilation and to allow fresh air to circulate,
there must be openings in the kitchen cabinet, following
the dimensions indicated.
- Cut the cabinet before inserting the hob and carefully
remove shavings or sawdust.
Fig. 1a/1b
ATTENTION! Failure to install screws and fasteners in
accordance with these instructions may result in electrical
hazards.
Operation
Control panel
The hob has a smart and sophisticated wireless
communication system, able to communicate with some
special connectible Elica hoods. Depending on the use of the
hob and what you are cooking, such hoods receive
information from the surface, process it and automatically and
optimally activate so as to eliminate any waste. See
www.elica.com to check the range of hoods connectible
with your hob.
Note: To select the commands, simply touch (press) the
symbols representing them.
Main Functions
1. Hob ON/OFF function
2. Timer
3. Operating level (power) adjustment and cooking
zone selection ring.
4. Pre-set operating level (power) selector
5. Cooking zone display*
6. Timer display
*
The number and position of the displays varies depending on the
model of your hob.
20