Movement ROCK AIR ROWER Manual Do Proprietário página 64

EQUIPMENT ASSEMBLY
CAUTION!
Before starting the installation of the equipment, it is necessary to pay
attention to the following precautions:
•Make sure that the packaging is not damaged and that the parts and
components of the equipment are not defective.
•It is recommended that the oar be unpacked where it will be mounted.
•The assembly area should be clean.
•The floor must be flat and level to prevent rowing instability.
•The space around the oars should be clear, as described in this Manual (see
Operational Instructions Chapter).
•It is recommended that the oar be mounted away from moisture and away
from sunlight to prevent damage to the electronics of the equipment.
•Be sure to lift all parts included in the boxes. Check the component list for a
complete count of the number of parts included for correct assembly.
•The purpose of the icons is to instruct the user on which tool to use, how
many people to assemble or to tighten the screws in a given step.
In order to assemble the equipment, the following tools are needed:
TOOLS
Allen Wrench
n°5 Philips
n°6
n°8
SPACE
We recommend that for the safety of
the users the equipment be used in an
area that is not frequently used based
on the figure to the side. The access
and exit area can be common between
the oars used.
recommended to
Screw threader
medium torque
This assembly is
be done by
two people
60 cm
60 cm
16
ICONS
100%
50%
Do not
Perform the
completely
tighten
tightening of
the screws
the screws
TABLE OF SPECIFICATION OF SCREW
TIGHTWNING TORQUE
Diameter [mm] Torque [N.m]
M6 9-12
M8 22-29
M10 45-58
200 cm
200 cm
final
60 cm
60 cm