Tru-Test XRP EID READER Manual Del Usuario página 15

Appendix D – CONFiG XRP options
This table explains the options available on the Configuration tab.
Note:
Default values appear in bold.
Connection options Select the PC COM port to which the XRP Reader is connected.
Connect
Disconnect
Indicators
Buzzer on
off
LED steady
flicker
Input Signals
Aux. Input poll
event
Transmitter Settings
Tuning Mode fast
standard
Power Level low
high
Phase Switching 0
180
toggle
Tag Output Format
Data Format hex
decimal
Output Mode cont.
single
delay
(default=3)
Read Mode HDX
FDX-B
both
Tag Information Output
Country Spacer on
off
Animal Status on
off
ICAR on
off
Industrial on
off
Response Window
Command Window
When a COM port has been selected in the Connection Options field, click Connect to allow communication
between the PC and the XRP Reader.
Click Disconnect to prevent communication between the PC and the XRP Reader.
Buzzer will sound when EID tag is read.
Buzzer will not sound when EID tag is read.
Green LED illuminates for 1.5 seconds when EID tag is read.
Note: If EID tag stays within range, the Green LED will remain on.
Green LED illuminates briefly when EID tag is read.
Not applicable to current models of XRP Reader.
Not applicable to current models of XRP Reader.
For most situations, except when more than one antenna is present.
Use this tuning mode if more than one antenna is being used (see
on page 4).
Power consumption and read range is reduced.
Power consumption and read range is increased.
These settings are used when setting up for'Dynamic Field Operation'. For more information, contact Tru-Test
and request the technical bulletin ‚XRP Reader Dynamic Field Operation‛.
Output tag numbers as hexadecimal numbers (include numbers 0-9 and letters A-F).
Output tag numbers as decimal numbers (include numbers 0-9).
Output tag number each time it is read.
Output tag number once during the period defined in the delay field.
Number of seconds allowed for animal to leave the read range. If the tag enters the read range after the delay
time specified, it will be output again.
Only HDX tags will be read.
Only FDX-B tags will be read.
Both HDX and FDX-B tags will be read.
Adds a space between Country and National ID codes in the EID tag number e.g. 941 000011010868.
No space between Country and National ID codes in the EID tag number e.g. 941000011010868.
In addition to the standard 16 digit EID tag number, the prefix appearing on the tag will also be output. (e.g.
For a tag that reads 1 0 03 02 0 941 000011010868, the prefix 1 0 03 02 0 will be output in addition to the
16 digit EID tag number).
The prefix to the 16 digit EID tag number will not be output.
XRP Reader will issue a warning to the connected device if a non-compliant tag is read (invalid country code,
non-animal ISO tag).
Warning for non-compliant tag is disabled.
If a non-animal ISO tag is read, it will still be output.
If a non-animal ISO tag is read, it will not be output.
During troubleshooting, if commands are entered in the Command Window, responses are displayed here.
During troubleshooting, commands may be entered here. Responses are displayed in the Response Window.
Dual antennas Synchronisation
on page 4 or
15