Sensor Installation - Kübler LES01 Instrucciones De Utilizacion

4.2 Sensor installation

The assembly of the Ants LES01 is described below.
First mount the sensor on the cabin sensor fastening plate with the connecting screw. Do not tighten
the screw completely to allow further corrections.
There are basically three mounting possibilities in respective steps of 90° to mount the Ants LES01 on
the elevator car.
Fig. 1
Fig. 2
Ensure the correct position, which depends on the already mounted
band.
EN - page 19 (R60200.0009 4)