Installation; Ceramill Motion 2 - Amann Girrbach ceramill motion 2 Manual Del Usuario

5

Installation

5.1

Ceramill Motion 2

Countries with 100-115 V mains voltage
The machine is preset for a mains voltage of
230 V. When the mains voltage at the set-up loca-
tion is 100-115 V:
▷ Pull out the fuse compartment ([11] in Fig. 3 on
page 53) below the mains plug.
▷ Replace both T3.15 A fuses with the provided
T6.3 A fuses.
I N S T A L L A T I O N
5.1.1 Ceramill Motion 2 Set-up without
Ceramill Coolstream
Please refer to the separate Ceramill
Motion 2 set-up instructions.
_ The machine is intended exclusively for use
within dry, closed rooms.
_ A clearance of at least 200 mm is to be
observed sidewards, to the rear and upwards.
Minimum space requirements for the Ceramill
Motion 2 (incl. connections):
▪ Width: 920 mm
▪ Depth: 790 mm
▪ Height: 955 mm
_ The empty weight of the machine is 78 kg (five-
axis model), resp. 75 kg (four-axis model). The
set-up surface must withstand an appropriate
load.
_ During operation, the room temperature must
be between 18 °C and 30 °C; avoid large varia-
tions in temperature.
▷ Set up the machine on a sturdy work table or
work bench (off the ground and clear of walls).
▷ Adjust the height of the machine by screwing
the feet in or out, ensuring that the machine is
positioned firmly on all four feet.
▷ Insert the extraction hose of the extraction sys-
tem being used (e.g. Ceramill Airstream) to the
extraction connection [7] on the rear side of the
Ceramill Motion 2.
▷ Connect the compressed-air hose on the rear
side of the Ceramill Motion 2
E N
57