Switching From Wet To Dry Processing; Switching From Dry To Wet Processing - Amann Girrbach ceramill motion 2 Manual Del Usuario

A P P L I C A T I O N A N D O P E R A T I O N
6.1

Switching from Wet to Dry Processing

The Ceramill Motion 2 can be used both for wet
E N
and dry processing.
6.1.1

Switching from Dry to Wet Processing

1
Fig. 18
1 Extraction hood
2 Lever
3 Swarf sieve
4 Splash guard
5 Extraction hood
B Service button
▷ Disengage lever [2] and pull off the white
extraction hood [1] toward the front.
▷ Connect the extraction hose to the extraction
opening in the milling chamber.
▷ With the door open, briefly press service button
[B] on the front side of the Ceramill Motion 2.
The extraction system starts.
▷ Allow the extraction system to clean out the
milling chamber by means of vacuum.
68
2
B
In delivery condition, it is set up for dry process-
ing.
4
When the milling chamber is clean:
▷ Press service button [B] again.
The extraction system stops.
▷ Pull off the extraction hose.
▷ Insert the cleaned swarf sieve [3].
The wide side faces toward the rear.
For wet processing, it is mandatory to use
the swarf sieve [3]. The sieve serves as the
first coolant/lubricant filter stage for
coarse particles.
▷ Check if the outlet holes of the C/L nozzles are
unobstructed.
5
3