Metra 99-7803G Instrucciones De Instalación página 5

3. Slide the radio into the kit
assembly and secure with screws
supplied with the unit. (Figure B)
4. Mount the (2) Panel Clip Legs
to the Radio Trim Panel with the
provided (4) #4 Phillips screws.
Attach the (2) Panel Clips to the
legs. (Figure C)
Clip leg locations
(Figure C)
Kit Assembly
(Figure B)
99-7803G
5. Locate the factory wiring harness
and antenna plug in the dash.
Refer to the wiring section of
this manual.
6. Mount the included speed clips to
the bottom mounting legs of the
radio brackets. (Figure D)
7. Mount the new radio assembly
into the dash, use the two included
#10 screws for the bottom support
screw and reassemble dash in
reverse order of disassembly.
Note: The door on the factory
pocket below the radio will not
function properly with this new
kit installed. As an alternate
solution, Metra offers the
88-00-7803 replacement
pocket sold separately.
5
(Figure D)