Dash Disassembly - Metra 99-7803G Instrucciones De Instalación

1. Unsnap and remove shift lever trim
ring. (Figure A)
2. Unsnap coin tray/ashtray from
assembly and remove. Rubber
cover may come out first but entire
assembly must be removed to
access screws below. (Figure B)
3. Remove (2) Phillips screws from
under coin tray/ashtray and
remove entire assembly. (Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
99-7803G
4. Remove (2) Phillips screws from
bottom of pocket assembly and
unsnap and remove. (Figure D)
5. Remove (2) Phillips screws facing
up under radio/climate control
assembly.) (Figure E)
6. Push and hold the hazard button
down. Carefully insert a flat blade
screwdriver into the slot below the
button and push down to release
the center clip. (Figure F)
Continued on next page
2
(Figure D)
(Figure E)
(Figure F)