Screw Retention; Cable Routing; Cable Bending Radius - Kübler Ants LES02 Manual De Instrucciones

4 Installation

4.1.6 Screw Retention

Secure the fastening screws against loosening. This is achieved, depending on the application,
using e.g.
• Coated screws
• Threadlocker
• Schorr washers
Kübler recommends a threadlocker, e.g. Loctite (order code: 8.0000.4G05.0000).
We recommend an additional protection against manipulation by marking the fastening screws
with locking varnish or similar.

4.1.7 Cable Routing

NOTICE
Wiring
When wiring the facility, pay attention to proper cable routing.
• Separate the wiring into power groups such as motor/power supply lines and signal and data
lines.
• Route the signal and data lines as close as possible to ground surfaces (frames, metal rails,
cabinet sides) and not parallel to motor and power supply lines or other lines carrying high in-
terference levels.
• Do not connect other users with high interference levels (such as frequency converters,
solenoid valves, contactors) to the power supply of the device.

4.1.8 Cable Bending Radius

R
min
ø d
The following minimum values (R
Fixed installation
Flexible use
42 - EN
Cable Routing
Route the sensor cable free of any tension, so that no additional
force is applied on the measuring system. Consider the minimum
bending radii of the connection cable.
Comply with the instructions in chapter
Information for EMC-Compliant Installation [} 44].
) apply for the measuring system with cable outlet:
min
R
min
32 [1.26]
64 [2.52]
BA Ants LES02 - R60073.0009 - 02
Kübler Group