Siemens VersiCharge Manual De Instalación Y Funcionamiento página 19

• The unit arrives factory-configured for either bottom fed cord-and-
plug installation or fed from behind cord-and-plug installation.
• Remove cord-and-plug assembly
• Open hinged cover by loosening four cover Phillips closure
screws.
• Remove barrier (two 3/32 inch hex screws)
• Remove the cord-and-plug assembly from the conductor
opening.
• Disconnect the L1 and L2 conductors on the bottom of the
lug block, and the Grounding connection from the ground
bar.
L1 and L2
• The L1 and /L2 conductors on the top of the lug block
© 2012 Siemens Industry, Inc.
and the ground connection leaving the top of the ground
bar should not be disturbed.
- 18 -
Document Number: 813540