Cord Management; Delay Timer - Siemens VersiCharge Manual De Instalación Y Funcionamiento

Ocultar thumbs Ver también para VersiCharge:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Pressing the 'Pause' button again will move the VersiCharge to
the 'Ready to Charge' state, and if a charge is required, the
VersiCharge will automatically begin charging and move to the
'Charging' state.
• If the device continues to experience immediate faults, contact a
qualified service person for assistance.

4.4 Cord Management

The VersiCharge has a built in cord management system.
• When not in use, the connector cord should be looped over the top
of the VersiCharge to prevent accidental damage.
• The connector should be plugged into the connector holster on the
front of the VersiCharge to prevent accidental damage.
• While in use, the cord can be unwrapped, loop by loop, to allow a
sufficient length of cord to be unwound to reach the vehicle
receiver.
WARNING! Failure to properly protect the connector and cord could
result in damaged components, which could prevent the VersiCharge
from functioning properly or create a hazardous situation.

4.5 Delay Timer

The VersiCharge has a built in delay timer to allow users to select the time
that they would like their vehicle to charge. The delay timer will prevent
the VersiCharge from entering the 'Charging' state for the selected length
of time.
© 2012 Siemens Industry, Inc.
Document Number: 813540
- 27 -

Publicidad

Tabla de contenido
loading

Tabla de contenido