Faults - Siemens VersiCharge Manual De Instalación Y Funcionamiento

• If the vehicle does require a charge, the VersiCharge will
automatically switch to the 'Charging' state. An audible click is
present when the VersiCharge goes into and out of the 'Charging'
state.
• Once the charge is complete, or the vehicle sends a signal to
stop charging, the VersiCharge will automatically return to the
'Ready to Charge' state.

4.3 Faults

The VersiCharge will automatically disconnect power in the event of a
fault.
• If a fault occurs during charging, the VersiCharge will disconnect
power from the vehicle, with an audible click, and change to the
'Fault' state. The VersiCharge will automatically self-recover when
all faults clear, with the exception of grounding faults.
• For grounding faults, after 15 minutes, the VersiCharge will attempt
to continue charging, and if no faults are present, will return to the
'Charging' state. During this 15 minute delay, the '2 Hour Delay'
indicator is illuminated.
• If a fault is still present immediately after the VersiCharge re-enters
the 'Charging' state, the VersiCharge will return to the 'Fault' state,
and remain in that state until it is manually reset.
• To reset the device, press the 'Pause' button, which will take the
device to the 'Pause' state.
© 2012 Siemens Industry, Inc. Document Number: 813540
- 26 -