Spark Plug - Haojue DM125 Manual De Uso

2. Remove the oil collecting pipe 2 together with the
clamp 1.
3. Drain all the waste liquid in the oil collecting pipe 2.
4. Reinstall the oil collecting pipe 2 and fasten the clamp
1.
NOTE: Be true that reinstall the collecting pipe.
NOTE: When air is very humid, properly increase the
inspection frequency.

SPARK PLUG

Spark plug inspection
Measure the spark plug gap with a thickness gauge. The
standard spark plug gap is 0.6–0.8 mm. If the measured
spark plug gap is out of standard range, adjust or replace
it with a new one.
Whenever removing carbon deposits, be sure to observe
the operational color of the spark plug's porcelain tip. This
color tells you whether or not the standard spark plug is
suitable for your type usage. A normal operating spark
plug should be very light brown in color. If the spark plug is
very white or glazed in appearance, it has been operating
much too hot. This spark plug should be replaced with a
colder plug.
Haojue DM125/DM125S 99011H2E120H000 V02 ES+EN+FR 2014-11-27
0.6–0.8mm
33
Haojue DM125/DM125S 99011H2E120H000 V02 ES+EN+FR 2014-11-27
Spark plug replacement guide
BCAUTION
An improper spark plug may have an incorrect fit or
heat range for your engine. This may cause severe
engine damage.
BCAUTION
Use one spark plug listed below or equivalent.
Consult your Haojue dealer or a qualified mechanic
if you are not sure which spark plug is correct for
your type of usage.
NHSP LD TORCH
If the standard spark plug is apt
D7RTC D7RC
to get wet, replace with this plug.
Standard.
D8RTC D8RC
If the standard spark plug is apt
to overheat, replace with this
D9RTC D9RC
plug.
NOTE: This motorcycle uses a resistor-type spark plug
to avoid jamming electronic parts.
plug selection may cause electronic interference with
your motorcycle's ignition system, resulting in motorcycle
performance problems. Use only the recommended spark
plug.
(95)
Remarks
EN
Improper spark
(95)