Setting Function Block Parameters; Exiting, Running, And Stopping The Program - Mitsubishi a SIMPLE APPLICATION CONTROLLER Manual Del Usuario

α
Simple Application Controller
6.3

Setting Function Block Parameters

Some Function Blocks have parameters that need to be set. These parameters
include Time (T), elapsed time (t), Set Repetitions (N), actual repetitions (n),
Set/Reset Priority and more.
Use the arrow keys to move to the FB. When the FB number is flashing, enter
OK twice to enter the FB Setup mode. Adjust the options to fit the program
requirements (refer to Key Operations Table 6.1). Enter all the necessary data
on each screen before using the OK button to accept.
Some FB have multiple option screens available. Use the ESC key to move to a higher screen without saving
the contents to system memory. When finished entering data, use the ESC button to return to higher screen
levels until the main programming screen is shown again.
6.4

Exiting, Running, and Stopping the Program

Use the ESC button to enter the Edit Menu (the ESC button might have to be
pressed more than once) and use the Exit option to leave ProgEdit.
Use the Run option to begin the program. Confirm with OK. When the program
is running the front screen is shown with the time, date, and image table.
Press any key to enter the Top Menu where the Stop option is located. Enter
this option to Stop the program and confirm with OK.
Other options that can be selected include:
ClockSet - Set the Real Time Clock.
Language - Choose English, Japanese, German, French, Italian, or Spanish
How to Use α α α α Series Controllers - Getting Started 6
B 0 3 : F L
O n T i m e
T = 0 . 0 s
t = 0 . 0 s
E d i t M e n u
P r o g S i z e
J u m p
N e w F B
E x i t
M n e m o n i c
T o p M e n u
R u n
P r o g E d i t
P r o g C l e a r
C l o c k S e t
L A N G U A G E
O t h e r s . . .
25
ENG