BRITAX Child Safety, Inc.
Child Seat Functions
Adjusting the Harness Height
• In rear-facing mode, the harness straps should be
in the closest position at or below your child's
shoulders. See page 7.
• In forward-facing mode, the harness straps should
be in the closest position at or above your child's
shoulders. See page 7.
1. Loosen the harness.
a. Lift harness adjuster
lever.
b. Pull both harness
straps forward.
2. Unhook both harness
straps from the yoke.
3. Pull one harness strap
through the shell and
cover to the front of the
child seat.
4. Feed the harness strap
through the desired
harness slot in the cover
and shell to the back of
the child seat.
NOTE: Repeat steps 3
and 4 for second harness
strap.
5. Nest the harness straps
by inserting the right strap
loop into the left strap
loop.
22
1b
1a
6. Before reattaching the
harness straps to the
yoke, hold the harness
yoke as shown, and
ensure that the adjuster
strap attached to the yoke
is not twisted.
7. Slide nested harness
straps completely onto
the harness yoke.
Adjusting the Harness Buckle Position
• For rear-facing installation:
– ALWAYS position the buckle in
the inner slot for when using a
vehicle seat belt installation.
– The vehicle belt must pass in
front of the buckle strap.
– Position the buckle in the slot
closest to but not under the child when using the lower
anchor installation.
• For forward-facing installation, use the outer buckle slot
when installing the child seat with a child weighing 30 lbs
(13.6 kg) and above or if the buckle is under the child in
the inner position.
• NEVER leave the buckle in the adjustment slot.
1. Unbuckle the harness.
Remove the belly pad and
push the buckle through
the cover.
2. Turn the buckle webbing
and slide it between
buckle positions.
3. Slide the buckle retainer
into the buckle slot, and
ensure the red release
button faces out.
ROUNDABOUT User Guide
6
7
Adjuster
Strap
ADJUSTMENT
SLOT
23