First Start-Up - Stalgast 803020 Instrucciones De Uso

Any other way of leveling the appliance should be approved by the manufacturer.
The packaging materials should be kept away from children and pets, as they can cause an accident. All
materials used to pack the product are environmentally friendly and can be safely stored in a suitable place.
Recyclable components are marked as follows:
•
PE – polyethylene: external packaging components, manual jacket, fastening components;
•
PP – polypropylene: grips;
•
Wooden and cardboard components must be left in places intended for this purpose in accordance with
applicable law.
It is forbidden to store the appliance and its components directly in the environment.
4.2. Connecting the appliance to a power source
Connecting the appliance to the mains can only be carried out by the technical service personnel in
accordance with applicable law. The electrical parameters of the appliance are included in the table in
section 3. It is forbidden to make one electrical safeguard for two appliances. It is necessary to install a main
circuit breaker and an earth fault breaker.
Both switches must be installed in an easily accessible location in such a way as to guarantee disconnecting
the appliance from power supply in accordance with the category II.
The appliance is fully disconnected from the power supply only when the main switch is set to OFF.
The appliance must be connected via the terminal placed in the rear, lower part of the appliance. Protective
earth (PE) is marked in yellow-green, neutral (N) in blue, and phase conductors (L1, L2, L3) in black, gray,
and brown, respectively.
4.3. Connecting the appliance to the water mains
Water hoses and the power cord are protruding from the rear. The water supply hose must be connected
to a 3/4" outlet. The connection should be closed only with the use of a brand new hose. In order to
observe safety, water pressure should be between 2-4 bar. Should the pressure be higher, a pressure
reducer should be installed. The main valve should be installed above the hose feeding water into the
appliance. The main valve should be installed in an easily accessible place; therefore, it should not be
installed behind the appliance. The appliance is equipped with a drain pipe, which should be installed at
floor level with the use of a vent.
Before starting the appliance, make sure that the supply and drain hoses are not bent, blocked or
otherwise damaged during installation.
4.4.Drain hole
The device is equipped with adrain pipe which should be installed at fl oor level with the use of siphon
Before starting the device, make sure that the supply pipe and the drain pipe were not bent, jammed
or otherwise damaged during installation

4.5. First start-up

Before starting the appliance, check the correct operation of the electronic safety system. The above
steps and the first start-up may only be done by technical service personnel, who will also conduct a short
training in the operation of the appliance Each appliance is equipped with an adjustable rinse aid dispenser.
In contrast, the adjustable washing liquid dispenser is only supplied with some models. A container for the
washing liquid and rinse aid must be put in place and then connected to suction tubes: the transparent one
to the washing liquid, and the blue one to the rinse aid. To adjust, use the adjustment screws shown in (Fig.
2). It is recommended that adjustments be made by the staff of the company providing the rinse aid and
.
- 34 -