Error Table; Problems, Causes, Solutions - Stalgast 803020 Instrucciones De Uso

Inserting another basket with dirty dishes and closing the door of the appliance results in an automatic
restart of the washing and rinsing (steaming) process.
7.

Error table

Error code Error description
EP 1 filling time exceeded, but a second attempt was taken
EP 2 filling time exceeded twice, attempt aborted
E1 LO too low temperature at probe T1 (below 0 degrees) (or open circuit)
E1 HI too high temperature at probe T1 (over 110 degrees) (or short circuit)
E2 LO too low temperature at probe T2 (below 0 degrees) (or open circuit)
E2 HI too high temperature at probe T2 (over 110 degrees) (or short circuit)
E3 LO too low temperature at probe T3 (below 0 degrees) (or open circuit)
E3 HI too high temperature at probe T3 (over 110 degrees) (or short circuit)
E4 interruption in power while the dishwasher was working
Et boiler overheating
E1 temperature difference between probe T1 and T2 is too high (>30°C)
E2 temperature safety limit exceeded - error displayed after emergency flushing
Note! In the event of a larger number of errors displayed simultaneously, the one with the highest priority -
a fatal error - is displayed.
8. Emptying the dishwasher (optional)
1. Switch off the appliance by pressing STOP
2. Open the door, pull out the plug and the screen
3. Activate the drain pump by pressing a button
9. Emptying the dishwasher in models not fitted with a drain pump
1.
Switch off the appliance by pressing STOP
2. Open the door, pull out the plug and the screen
3. As soon as the water has been drained from the tank, place the overflow cap and the screen
back in their place.
Do not turn off the machine when the water is still in the tank. Always empty the tank of water before
turning the appliance off. In the event of ending work with the appliance, after performing the above, and
possibly initiating a regenerative cycle, it is mandatory to switch off the device by pressing the switch and
then turning off the main switch and closing the water tap.
7.

PROBLEMS, CAUSES, SOLUTIONS

Note: if the steps in the table below, aimed to remove the fault, did not produce the desired result, contact
your service (qualified technical personnel).
PROBLEM
The device does
not run
Excessive washing
duration
CAUSE
Appliance door does not close
Burnt fuse
Improper connection to the power grid
The temperature of the washing water
is not right
Abnormal level of water in the appliance
- 41 -
SOLUTION
Opening and re-closing the door
Replacing the fuse (call for service)
Check the electrical connection
Setting a suitable temperature
Clean the water inlet filter