Button Functions - Stalgast 803020 Instrucciones De Uso

6.3. WASHING PROCEDURES (803020)
1. Control panel
2.

Button functions

Fig. 6
3. Starting the appliance
Activate the switch placed on the wall and press the On/Off (Fig. 7). Then open the hood of the dishwasher,
put the overflow plug in place (Fig. 6), put the basket into the chamber and select the program (Fig. 10).
After closing the hood, the appliance will start filling its tank and the boiler with water - the boiler pilot light
will illuminate (Fig. 9). Once the water in the boiler is heated up, the dishwasher chamber starts heating
up the water - a pilot light of the heater compartment light will illuminate (Fig. 9). The washing cycle will
start automatically - the indicator light will illuminate (Fig. 8). If you open the door during the wash cycle,
the program stops automatically. After closing the door, the program continues the wash cycle. After
completing the program, the wash cycle indicator light turns off (Figure 8). Remove the basket from the
chamber of the appliance. Note! Each operation that involves closing the hood starts a new dishwashing
cycle.
4. Emptying the tank in models equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance,
remove the overflow plug (fig. 6) and close the hood. The drainage process begins automatically and
continues until the tank is completely emptied of water. In order to activate the appliance place the
overflow plug back in its place, close the hood of the appliance, and then press the power button. However,
if the appliance is not already in use, turn off the main switch.
5. Emptying the tank in models not equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance,
remove the overflow plug (fig. 6) and wait until the water leaks from the tank completely. Place the
overflow plug back in its place, close the hood of the appliance.
Fig. 7
On/O
- 37 -
Fig. 8 Fig. 9
Wash cycle Indicator
light for cham-
ber and boiler
heaters
Fig. 10
Selecting program
2 - 120 sec. / 3 - 180 sec.