CRESTO RESQ RED PRO Mk I Manual De Instrucciones página 12

Supporting the use of the device, once the manual have been read and understood and
post sufficient training, you will find the following pictogram (Fig 1 and 2) together with the
individual ID sticker on all devices.
CAUTION!
Certified and temporary anchorpoint MUST sustain the load
of min. 12kN per person.
Fig 1
NOTE! Both descend modes are identical for double descends!
The yellow sticker is situated on the edge of the hand wheel as shown (Fig 2) on the ren-
dering on page 9. and the pic. below. This sticker is identical to the one situated on the lid
of the red box. On the side of the hand wheel you will find the red reminder on reading and
understanding the manual.
First rendering, pic. 1 and 2 is a short reminder of how to connect at a safe anchor point
sustaining a load of min. 12 kN and how to exit, during evacuation, as taught in training and
supported by this manual.
Second rendering, pic. 1, 2, 3 and 4 is a similar short reminder on how the execute a "lad-
der rescue" in the right sequence. Step 1: Mount the device and connect to the casualty.
Step 2: block and open the hand wheel. Step 3: Disconnect the blocking pin and initiate
the hoist. Step 4: Fold the hand wheel and execute the descend, as taught in training and
supported by this manual.
On the front cover shown underneath and on page 7 you will find the mandatory ID sticker
with references to the supplier, certification and limitations in use, and traceability.
© CRESTO AB 2016 | UK Master vers. 2016 - 1 | Rev. 21.06.2017
LIFTING/HOISTING
Fig 2
| 9