Blodgett SG2136 Manual De Instrucciones página 18

Installation
Oven Assembly
OPTIONAL REMOTE COMPUTER CONTROL
1. Remove the four side screws. Disassemble
the mounting bracket assembly from the
housing.
2. Use the mounting bracket as a template to
mark the location for installing mounting bolts
into the wall.
NOTE: The mounting bolts are not supplied.
Up to 1/4" diameter bolts can be used.
The bolt type should be determined by
the wall construction.
Operator
Control
3. Attach the mounting bracket to the wall.
4. Slide the remote housing over the mounting
bracket. The holes on the sides of the housing
must line up with the holes on the sides of the
bracket. The control cable will line up with the
large slot in the mounting bracket.
5. Secure the housing to the mounting bracket
with the screws removed in step 1.
6. Be sure the operator control is well seated into
the housing and bracket.
Remote
Housing
Figure 14
16
Remote Mounting
Bracket Assembly