K - Checking The Wear Status Of The Three Wheels; M - Battery Charger Configuration - Ghibli & Wirbel R 150 FD 85 Instrucciones De Uso

12.1.k - Checking the wear status of
the three wheels (Fig. 25)
- Check the wear status of the three
wheels (8) and (23) periodically; if they
appear worn or damaged, contact a tech-
nical service centre in order to have them
replaced.
DANGER:
Operating the machine with worn or dam-
aged wheels poses a danger to the oper-
ator as the machine could have less trac-
tion when turning.
12.1.l - Replacing the fuses (Fig. 26)
WARNING:
Replace the blown fuse with one with the
same amperage.
- To change the fuse (70) on the positive
pole of the battery, proceed as follows:
WARNING:
Make sure the recovery tank is empty.
- Pull the plug (26) out of the socket (5).
- Lift the recovery tank (11) using the spe-
cific handles (25).
Fuse (70) - 150A
Battery fuse.
Fuse (71) - 10A
Dashboard fuse.
- For the fuse rearmament (71) remove the
panel (72) unscrewing the related screws
and work on the button (49) to rearm it.
12.1.m - Battery charger configura-
tion (Fig. 27)
WARNING:
The machine comes pre-configured for
use with "Sonnenschein" gel batteries.
DANGER:
This operation must be performed only by
a qualified technician.
Standard configuration with Sonnen-
schein gel batteries
- Take off the case (A) of the external bat-
tery charger and check that the switches
(1 - 2 - 3 - 4) are set to the configuration
shown in figure (B).
Perform the following operations to modify
the configuration:
Configuration for gel batteries other than
the Sonnenschein typology
- Check that the switches (1 - 2 - 3 - 4) are
set to the configuration shown in figure
(C).
Configuration for acid batteries
- Check that the switches (1 - 2 - 3 - 4) are
set to the configuration shown in figure
(D).
WARNING:
Only modify switches (1 - 2 - 3 - 4); do not
alter the positions of switches (5 - 6 - 7 -
8).
EN - 20
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968