Publicidad
\
To install bagger components
to tractor
1.
Discharge
Chute
2
2.
3/8 Nut
3.
Flat Washer
3
1. Support Bracket
2. Clevis Pin 10 x 17mm
3.
3/8 Lock Nut
4.
3/8 x 63,5mm Hex Bolt
5.
10,3mm
(13/32")
flat
washer
6.
Retainer Spring
1.
2.
3.
Removedischargechutefrom
rear oftractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
3/8 Lock nut
Flat Washer
Support Tube
Using
the nuts
and flat washers
removed
from
tractor
back plate,
install
the bagger
support
tube
to the back
plate as shown.
Tighten
securely.
Install
the two upper support
brackets
through
the back
plate and to the
chassis,
install the clevis
pin 10x17mm
and secure
with retainer
spring.
Assemble
both
support
brackets
to the outside
of the
bagger
support
tube
using
two each
3/8 x 63,5mm
hex
bolts13/32"
I.D. flat washers
and 3/8 Iocknuts
from parts
bag. Tighten
securely.
1.
Hook
2.
Discharge
Chute
3.
Back plate slot
Replace
discharge
chute
into
rear
opening
of tractor.
Secure
the chute with the two hook straps.
NOTE:
The strap hook must go through
the discharge
chute
only.
Do not allow the hook
to enter
the slot in the tractor
back plate. This will allow the discharge
chute to float with the
mower
deck when moving
on uneven
terrain.
24
Publicidad
