Publicidad
1.
Front bagger
tube
2.
Vinyl
binding
3.
Spreader bars
4.
Retainer spring
5. Vinyl binding
5
\
4
4
@
To Assemble
Bagger
Unfold bag by pivoting front bagger tube alltheway forward
and pressing the bottom vinyl binding onto the tube.
Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
Press the vinyl bindings onto the sides of front bagger
tube.
Slide
the bagger
dump
handle
through
the hole in the
bagger
top, install the clevis
pin 10 x 44mm
and secure
with retainer
spring.
Push cap over end of bagger
dump
handle.
NOTE:
For future use, the clevis
pin may be removed
in order
to use the handle to clear the chute in the event it has become
clogged.
Bagger
adjustment
For proper bag function and appearance,
it may be neces-
sary to adjust the bagger assembly. There should be 6mm
(1/4")-9mm (3/8") gap between the bagger top and fender and
the bagger top surface should be even with the top surface
of the fender. To adjust bagger position:
6.
7.
8.
9.
7
8
Dump handle
tube_
Clevis
pin 10 x 44mm
Retainer
spring
Cap
|
i
9
1.
Top Surfaces
Even
2.
Horizontal
Adjustment
Bracket
3.
Vertical
Adjustment
Bracket
4.
Bagger
Latch
2
6MM (1/4")-
9_,_M(3/8"}
Horizontal
adjustment
Slightly loosen the nuts securing the bagger RH and LH
horizontal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
Move the brackets the amount forward or backward you
wish the bag assembly to move. Retighten the nuts se-
curely.
Vertical
adjustment
Slightly
loosen
the nuts securing
the vertical
adjustment
brackets.
Loosen
only enough
so the brackets
keep their
position,
but allow them
to be moved.
Move the brackets
the amount
up or down you wish the
bag assembly
to move.
Retighten
the nuts securely.
Reinstall
the bagger
assembly
and check
the bagger
to
fender fit. If necessary,
repeat the procedure
until proper
fit is attained.
After
proper
fit is attained,
remove
bagger
from tractor
and install bagger
latch (4) to tractor
back plate as shown.
Tighten
securely.
Install and carefully
lower bagger
to actuate
latch.
Measure
distance
between
bagger
and latch as shown.
If distance
is not 10mm - 16mm carefully
remove
bagger
and repeat
vertical
adjustment
as needed.
±
To convert
to
bagging,
mulching
or
discharge
See "Section
5" of this
manual.
25
Publicidad
