Standby/Service Mode; Turning The Decorative Lighting On And Off; Service Menu - KBL megaSun 5600 Manual De Instrucciones

Standby/service mode

In standby mode, you can turn the decorative lighting
of the device on and off. In service mode, settings
for operation in tanning mode are made, and certain
values concerning the operation of the unit can be
displayed.
Turning the decorative lighting
on and off
Press the buttons in the following order to turn the
decorative lighting on or off: 5 0 5. Make sure that
you carry out the keystrokes quickly one after the
other!
In addition to this manual setting, you can go to the
service menu and program a timer providing two
independent activation and deactivation times.

Service menu

There are two service levels that can be accessed via
passwords (PIN). Press the buttons 1 ... 0 to reach
these levels and to be able to initiate processes on
these levels. For this reason, the plus and minus
buttons are also marked with numbers.
Two conditions must be fulfi lled in order to access
the service screens:
•
No error message displayed
•
No incoming signal from the coin box/timer
system
If there is an error message pending, eliminate the
fault fi rst and then reset the message by pressing the
"Stop" button.
Figure 24.1 Buttons1 ... 0 for service mode
SERVICE LEVEL I
Press the sequence of buttons 1
enter the PIN 1 1 1 1 to access service level I.
SERVICE LEVEL II
This level contains service screens that are only used
by the Technical Service staff. You reach level II from
the "PIN II" menu on level I by entering the correct
PIN (not 1 1 1 1). Please request the PIN from
the KBL service organisation.
GENERAL NAVIGATION
After the service level I has been invoked, the
following applies:
•
Button 5: go forward within the menu
•
Button 0: go back within the menu
•
Stop button: exit the menu level, or exit the menu
•
Start button: select the menu item, or save the
displayed and changed value
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
6 1 and then
23