Tubes, Facial And Shoulder Tanners; P2 Tubes - KBL megaSun 5600 Manual De Instrucciones

Tubes, fa cial and shoulder
tanners
DISMANTLING
Proceed as follows in order to be able to clean or
replace tubes, facial tanners or shoulder tanners:
Procedure
Dismantle the canopy, bed and side
1 panes.
Remove the tube covers in the facial and
2
foot areas.
For units equipped with tanning
lamps, you must also remove the
3
fi lter panes if you wish to replace the
lamps.
Remove the covers of the shoulder
4
tanner.
CLEANING CYCLE
In order to preserve the tanning effect, we recommend
cleaning the tubes and UV lamps with warm water
and a chamois after approx. 200 hours of operation.
Do not use any cleaning agents that are aggressive or
contain alcohol.
REPLACEMENT CYCLE
Only replace tubes, facial tanners, shoulder tanners
and starters with ones of the same type. When
installing the tubes, make sure that the inscription
is visible. In this position, the refl ector of the tube
is at the back. If your tanning unit is equipped with
CPI, you must carry out a reset after each tube
replacement. As far as inductive units are concerned,
also replace the starters with each tube replacement.
Reset the operating hours counter of the tubes after
each replacement.

P2 tubes

The maintenance and cleaning frequency of the P2
tubes correspond to the intervals applicable for the
standard tubes.
Figure 41.1: P2 tubes in the canopy
Fig.
39.1
39.2
39.3
40.1
40.2
Figure 41.2: Detailed view (P2 tube)
43.1
REPLACING P2 TUBES
There are two P2 tubes installed in the canopy of the
tanning unit (
Proceed as described in the section "Tubes, facial
tanners and shoulder tanners" to replace the P2
tubes.
When dismantling and installing the P2 tubes, pay
attention to their centre retaining clamp (
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
.
fi gures 41.1; 41.2; 42.1)
.
fi gure 42.2)
41