Functions C'M'A'B; Air-Conditioning Functions; Setting The Operating Hours Of The Tubes - KBL megaSun 5600 Manual De Instrucciones

Functions C'M'A'B'

Depending on the confi guration of your system, the
PIN II/CMAB
menu item
off certain functions.
PIN II
1. Invoke the
2. Set the desired value by pressing the plus and
minus buttons of the corresponding letter.
3. Save the settings by pressing START, press STOP
to leave the menu.
C (Channel) is deactivated if only external channel
selection with exactly one channel is available as
audio system for the unit. The channel-selection
symbol is not displayed.
M (Music) is deactivated if there is no audio system
available. No symbols regarding the audio system
are displayed.
A (Air-conditioning unit) is not displayed if the tanning
system is not equipped with an air-conditioning
unit. No symbols regarding air-conditioning are
displayed.
B (Facial tanners) You can switch the facial tanners
on or off here.

Air-conditioning functions

PIN II/ACS
The menu item
for the control of the air-conditioning system:
PRESETTING AIR-CONDITIONING UNIT (AIRCON)
Use the menu item
conditioning unit should start automatically at the
beginning of the tanning session (ON) or if it must be
activated manually by the studio customer (OFF).
PIN II
1. Invoke the
2. Press START to invoke the menu item
AIRCON
3. Select
(minus button).
4. Activate the function by pressing 4 (plus button)
or deactivate it by pressing 9 (minus button).
34
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
Settings on service level II
④ ⑤
allows you to switch on or
menu and enter the PIN.
includes three submenus
AIRCON
to specify if the air-
menu and enter the PIN.
ACS
by pressing 5 (plus button) or 0
5. Use the START button to save the settings and
press STOP to exit the menu.
INCREASING THE FAN SPEED (OFFSET)
The menu item
the fan should operate at a higher speed. An OFFSET
of 00-99% can be set in steps of 10 %. This measure
may become necessary in the case of poor venting.
Note that such modifi cations must only be carried
out by service staff!
1. Invoke the
2. Press START to invoke the menu item
OFFSET
3. Select
(minus button).
4. Press 4 (plus button) to increase the value or 9
(minus button) to decrease the value.
5. Save the settings by pressing START and exit the
menu by pressing the STOP button.
INCREASING THE FAN SPEED (A.START)
A.START
beginning of the tanning session. Values between 20
and 99% can be set. The value can also be changed
manually during the tanning session.
④
1. Invoke the
2. Press START to go to the menu item
A.START
3. Select
(minus button).
4. Press 4 (plus button) to increase the value or 9
(minus button) to decrease the value.
5. Press the START button to save the settings and
STOP to exit the menu.
.
Setting the operating hours of
the tubes
Go to the menu item
the operating hours of the tubes.
OFFSET
is used to defi ne whether
PIN II
menu and enter the PIN.
by pressing 5 (plus button) or 0
is used to specify the fan speed at the
PIN II
menu and enter the PIN.
by pressing 5 (plus button) or 0
④
PIN II/CM
if you want to enter
ACS
.
ACS
.