Maintenance and cleaning
Regular maintenance is required for the safe operation
of the tanning unit and must be documented. Cleaning
must be performed when necessary.
Live parts
Risk of fatal injury due to electric shock when
touching live parts.
•
Disconnect from mains and secure
against reconnection!
Instructions for cleaning and
care
GENERAL
•
Before starting to clean the unit, take off any rings,
bracelets, watches, etc. that you might be wearing
in order to avoid scratching the surfaces.
•
Cleaning fl uid must not run into the appliance.
TUBES
•
To preserve the tanning power, we recommend
cleaning the tubes and UV lamps with warm
water and a chamois after approx. 200 hours of
operation.
ACRYLIC PANES, GRAB HANDLES AND DOOR
HANDLES
•
If possible, use the special cleaning and disinfectant
agent "megaClean" supplied by KBL for cleaning
the acrylic parts and handles, and dilute it in water
at a ratio of 1:13.
VARNISHED AND PLASTIC PARTS
•
Use a damp soapy cloth to clean the varnished and
plastic surfaces.
•
Do not clean the large plastic parts with a dry cloth.
This might scratch the surfaces!
DANGER
CHROMIUM-PLATED PARTS/MIRROR PLATE OF
FLOOR
•
Only clean with a damp chamois and a cleaning
agent for acrylic plastic (antistatic). Apply the
cleaning agent onto the chamois and not directly
onto the mirror surface.
CLEANING AGENTS
•
The surfaces and the acrylic panes must not be
cleaned with concentrated disinfectants or solvents
or other liquids that contain alcohol!
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
37