Setting Date And Time; Entering Pin Ii; Setting Aquacool Characteristics - KBL megaSun 5600 Manual De Instrucciones

time using the plus and minus buttons 2, 3, 7, 8.
Press START. Proceed in the same way for
BON BOF
and .
4. Press STOP to leave the menu.

Setting date and time

The current time and date are set within the menu
TIME/DATE
item
the proper execution of the timer function for the
decorative lighting. Date and time are displayed for
approx. 2 seconds after the unit has been turned on.
TIME/DATE
1. Invoke the
2. Choose the time setting with START and set the
time by pressing the plus or minus buttons to the
corresponding number.
3. Choose the date setting using 5 (plus button) or
0 (minus button) and set the date by pressing
the plus or minus buttons to the corresponding
number. The day of the week is determined
automatically.
4. Save the settings using START and press STOP
to exit the menu.

Entering PIN II

By entering your PIN II here, you will be admitted to the
next service level. (See Settings on service level II ).
Setting aquaCool
characteristics
SETTING THE AQUACOOL CYCLE TIME
The menu item
interval between spraying cycles: between 0.5 and
5 minutes.
AAC
1. Invoke the
2. Press START to invoke the submenu and 5 (plus
button) or 0 (minus button) to select
3. Set the cycle time using 4 (plus button) or 9 (minus
button) .
4. Press the START button to save the settings and
leave the menu by pressing STOP.
30
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
④
. This information is required for
menu.
④⑤
④
AAC/Cycle
is used to set the
menu.
Cycle
PRESETTING TANNING MODE
AOF
, Use the menu item
whether aquaCool is started automatically with the
tanning session (
manually by the studio client (
1. Invoke the
2. Invoke the submenu by pressing START twice;
then press 5 (plus button) or 0 (minus button) to
AQUA
select
AQUA ON
3. Select
AQUA OFF
4. Save the settings by pressing START and exit the
menu by pressing the STOP button.
INITIALISING AQUACOOL
The menu item
spraying cycle of 90 seconds. This is required before
the start-up or after a repair in order to exhaust the
system.
1. Invoke the
2. Press START twice to open the submenu and
INIT
select
(minus button).
3. Start the spraying cycle by pressing 1 (plus
button).
4. Press STOP to exit the menu.
SETTING THE AQUACOOL SPRAYING TIME
The menu item
the duration of a spraying cycle: between 2 and 6
seconds.
1. Invoke the
2. Press the START button twice to invoke the
submenu, then select
(plus button) or 0 (minus button).
3. Select the spraying time by pressing 4 (plus
.
button) or 9 (minus button).
4. Save the settings with START and press STOP to
leave the menu.
AAC/AQUA/AQUA
AQUA ON
) or if it can be activated
AQUA OFF
AAC
menu.
.
by pressing 4 (plus button) or
by pressing 9 (minus button).
AAC/AQUA/INIT
is used to start a
AAC
menu.
by pressing 5 (plus button) or 0
AAC/AQUA/AQ.Time
AAC
menu.
AQ.Time
by pressing 5
to determine
).
is used to set