Connection Of The Can Communication For Li-Ion Batteries With Bms; Safety Instructions For Connecting The Can Communication For Li-Ion Batteries With Bms; Wiring Requirements For Connecting The Can Communication For Li-Ion Batteries With Bms - Ingeteam INGECON SUN STORAGE 1Play TL M Manual De Instalacion Y Uso

Ingeteam
13. Connection of the CAN communication for Li-Ion
batteries with BMS
Installing the CAN communication enables the inverter to control the Li-Ion batteries with BMS (Battery
Management System).
This chapter explains the requirements and process for connecting the CAN communication wiring for Li-Ion
batteries with BMS to the unit. Read carefully before starting the connection process.
13.1. Safety instructions for connecting the CAN communication for
Li-Ion batteries with BMS
CAUTION
Before you start to make the connections, make sure there is no voltage in the inverter. Check that the
protections for the grid/genset, critical loads, storage system and PV array are open.
Do not switch on the power to the unit until you have successfully made the rest of the connections and the unit
is closed.
When carrying out the connections, respect the polarities marked on the electronic card.
13.2. Wiring requirements for connecting the CAN communication
for Li-Ion batteries with BMS
The wiring gauge for connecting the CAN communication of the storage system management system is specified in
the following table:
Wiring gauge
Cable diameter
Wiring stripping length (L*)
L*
36

Connection of the CAN communication for Li-Ion batteries with BMS

INGECON SUN STORAGE 1Play TL M
0.25 mm ~ 1.5 mm
2
5 ~ 9 mm
8 mm
ABH2014IQM01_A- Installation and Operation Manual
2