Inglesina APTICA Instrucciones De Uso página 28

Should it be necessary, both front wheel assemblies (F) can easily be removed.
Pushing the small button (
support.
STORAGE BASKET
The chassis features a spacious storage basket (B
tube (A3), then attach the two lower slotted bands (B2) to the corresponding pins (A4).
Pass the two bands with button (B4) around the side tubes (
to the basket.
The zipped pocked (
functionality.
To remove the basket (B
(
them from the dedicated housings.
with the operations described above (
( ) in the dedicated housings (
to their correct layout, and secure both side hooks (
CLOSING THE CHASSIS
To close the chassis, press the button (
handle ( ) until the chassis closes completely.
The arrows (
closing position.
To transport the closed chassis, use the rear handle (
Never lift the chassis by the handlebar.
REAR WHEELS BRAKE
To operate the brake, push the lever (A11) on the right, on the rear axle.
Always engage the brake during stops.
BLOCKING/UNBLOCKING THE FRONT WHEELS
The chassis features swivel wheels that can be blocked or unblocked by operating
the lever ( ) on both front wheel assemblies.
ADJUSTING THE HANDLEBAR
The chassis features a telescopic handlebar, which can be adjusted to 4 different positions.
Operate both levers (A12) and simultaneously raise or lower the handlebar to the
desired position.
FEEDING BOTTLE HOLDER
The chassis is equipped with a standard feeding bottle holder (C).
To fasten the feeding bottle holder, place the upper guide in correspondence of the hook
(C1) on the chassis and push it in its housing until it is fully attached.
ADDITIONAL CARRYING UNITS FOR CHASSIS: BASSINET, STROLLER SEAT
The chassis can be used with the Aptica bassinet (G) and the stroller seat (J).
28
), pull the wheel assembly out from its housing in the
) on the basket increases its capacity and enhances its
) in reverse.
) beneath the front footrest, paying particular attention
) on the handle and chassis help to identify and reach the correct
B1) around the rear spacer
) from the corresponding front pins (
B) on the chassis, before proceeding
) to their respective front pins (
) and simultaneously rotate the rear
).
) and attach them
)
).