Inglesina APTICA Instrucciones De Uso página 30

ATTACHING THE STROLLER SEAT TO THE CHASSIS
Attach the stroller seat (J) to the chassis, positioning it in the dedicated housings
on both sides of the structure.
sides before use.
The stroller seat can be used both rear facing and forward facing.
DETACHING THE STROLLER SEAT FROM THE CHASSIS
Operate the lever (J1) and simultaneously lift the stroller seat from the chassis.
Caution: do not, under any circumstance, carry out this operation with the baby
inside.
ADJUSTING THE BACKREST
the backrest to the desired position.
ADJUSTING THE FOOTREST
To lower the footrest, use both levers (J3) positioned on the lower part and
simultaneously press them downwards.
To lift the footrest, simply pull it upwards and it shall automatically lock into
position.
SAFETY BELTS
Ensure that the safety belts are inserted in the eyelets at the height of the
shoulders or immediately above. If the position is not correct, remove the belts from the
height.
Make sure that the back strap is properly inserted in the ends of the waist one.
Fasten the ends of the strap belt to the central buckle.
The waist strap must always pass through the side loops (
used, it must be adjusted in order to properly secure the baby.
Always use the crotch strap together with the waist one, adjusting both of them
properly.
out, with serious injury risks.
ATTACHING THE HANDRAIL
To attach the bumper bar (K), press the buttons (K1) and attach it in the dedicated
housings (K2) in the stroller seat.
(K1
ATTACHING THE STROLLER HOOD
The hood (L) is mounted onto the stroller by positioning it in correspondence of
the 2 housings (L1) on the pushchair seat and inserting the slides (L2), pushing until they
both click into place.
Fasten the press studs of the lining to the backrest, starting with the upper ones
(L3) and then with the lower ones (L4).
To adjust the hood, simply accompany it to the desired position.
The hood features an additional fabric insert and sun shade that extend the degree
of cover, improving protection from the sun.
DETACHING THE HOOD FROM THE STROLLER
To remove the hood (L) from the stroller seat (J), detach the press studs (L3/L4)
30
APTICA STROLLER SEAT
J2) and bring
) and, when being