Entry Delay In Stay Mode; Quick Exit In Stay Mode; Silent Control In Stay Mode - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide
STAY MODE
Use Stay mode to partially arm the system when
individuals will be occupying the premises. This arms
only the sensor-protected perimeter doors and windows.
This leaves interior motion sensors or other interior doors
unarmed.
In a home setting, Stay mode is typically used during the
evening hours when occupants are no longer expected
to leave or enter the premises. This allows occupants to
move about the premises without triggering the burglary
alarm. Because all the interior burglary protection is OFF,
an alarm would only be triggered when a sensor-protected
perimeter door or window is opened.

Entry Delay in Stay Mode

Certain sensors, such as a door, can be configured by
your installer to use a delay timer before triggering an
alarm.
This provides a way for an authorized person to enter
using a predetermined door to disarm the system before
an alarm is triggered.
To arm the system using an Entry Delay:
1 At the Security or Menu screen, tap the Arm button.
2 At the Ready to Arm screen, place a check-mark in
the Entry Delay box. This is the default setting.
NOTE: If you un-check the Entry Delay box, an alarm
will be triggered when the sensor is opened while
armed in Stay mode.
3 Tap Stay to arm the system
NOTE: When re-entering the premises, the user must
enter through the door(s) programmed to use the Entry
Delay timer. This gives the user a specified amount of
time to disarm the system. If the system is not disarmed in
time, an alarm is triggered.

Quick Exit in Stay Mode

A programmable option, called Quick Exit may be
displayed on the Security screen while the system is
armed in Stay mode. Tap the Quick Exit button to start
a timer that allows someone to exit or enter through
a sensor-protected door that is programmed for delay
without having to disarm the entire system. When the
delay timer runs out, the system returns to the normal
Stay mode.
The Quick Exit option can be turned ON or OFF by the
installer. See "Installer Programmed Options", on
to understand the options that have been programmed for
your system.

SILENT CONTROL IN STAY MODE

Three options for silencing the beeps and announcements
are available when arming or disarming the system in
Stay Mode.
● At the Home or Security screen, tap the Silent
Control button.
● At the Ready to Arm screen, check the box adjacent
to the Silent Exit option.
● On the Exit Delay screen, tap Silence.
Selecting any of these options silences the Control Panel
beeps and announcements. When arming, selecting the
option doubles the length of the Exit Delay.
12
Burglary Protection
Copyright © 2019 Nortek Security & Control
page 34,