If A Burglary Alarm Occurs; Burglary Alarm Siren; Alarm Memory; Optional 2-Way Voice Communications - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide

IF A BURGLARY ALARM OCCURS

If an armed sensor is tripped while the system is armed
in the Stay or Away mode, an alarm occurs and the siren
sounds. Delayed sensors start the Entry Delay to allow time
to disarm the system. Instant sensors trigger the alarm right
away. Most sensors trigger the alarm siren, some sensors
may be set to trigger a silent alarm without sounding the
siren.

Burglary Alarm Siren

If a burglary alarm is tripped while the system is armed, the
Control Panel sounds the alarm siren for a preset time (see
"Installer Programmed Options" on
expires, the siren will stop.
The system limits the number of times a sensor can re-
trigger an alarm while the system is armed. The setting
is one to six times per sensor, per arming period (see
"Installer Programmed Options" on

Alarm Memory

If an alarm has occurred while the system was armed, the
Disarm screen shows the time and date of the alarm and
the sensor(s) that triggered the alarm.
After the system is disarmed, the Alarm Memory screen
appears. The Alarm Memory screen shows the sensor(s)
that caused the alarm. If more than one sensor was
triggered, the display shows the order in which the alarms
occurred.
page 34). After the time
page 34).
16
The alarm memory automatically clears the next time the
system is armed. You can also check the Clear Alarm
History box and tap OK to manually clear the alarm
memory (24-hour fire and CO sensors that are still violated
remain in alarm memory).

Optional 2-Way Voice Communications

2-way voice communications provides a method for alarm
verification and can provide emergency assistance. The
Control Panel contains a built-in microphone that can
monitor sounds around the area of the Control Panel.
The built-in microphone and speaker allow 2-way voice
communications with a Central Station operator after
an alarm. The operator can converse with people in
the premises through the Control Panel's speaker and
microphone.
Your installer can set the system to use 2-way voice
communications after an alarm and/or after a panic alarm is
triggered.
NOTE: If a panic alarm or sensor is set for a silent alarm,
the operator can only listen and will not be able to talk. This
is for your protection.

KEY FOB: ARMING AND DISARMING

Your system may be equipped with one or more wireless
key fobs. Up to eight (8) key fobs can be used to control the
system remotely. Each key fob has four (4) buttons and can
perform four (4) functions. A user code is not required when
arming or disarming the system with a wireless key fob.
Several key fob options can be set by the installer. See
"Installer Programmed Options" on

Arm with a Key Fob

Stay Mode
To arm the system to Stay mode using a key fob, tap the
Stay button.
NOTE: Depending on setup options, if any perimeter
doors or windows are open, the system may not allow
arming to Stay mode with a wireless key fob. See "Installer
Programmed Options" on

Away Mode

To arm the system to Away mode using a key fob, tap the
button.
NOTE: Depending on setup options, if any perimeter doors
or windows are open, the system may not allow arming
to Away mode with a wireless key fob. See "Installer
Programmed Options" on
Copyright © 2019 Nortek Security & Control
Burglary Protection
page 34.
page 34.
page 34.