Adjusting The Backlight Timeout; Cleaning The Touch Screen; Set Date And Time - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide
5 At the Toolbox (1 of 3) screen tap Brightness/Volume.
You can set the brightness using the top bar. Adjust the
level from 1 to 12 using the buttons on each end of the
bar.
6 You can set the speaker volume for the chimes and
announcements on the bottom bar. Adjust the level
from 1 to 12 using the buttons on each end of the bar.
NOTE: The volume setting does not effect the alarm
sounder volume.
7 When you are finished, tap OK.

ADJUSTING THE BACKLIGHT TIMEOUT

The backlight timeout sets the length of time that the
display stays lit after use. You can adjust the backlight to
30 seconds, 1, 2, 5, or 10 minutes, or to Always (to light
the display at all times).
NOTE: To conserve the Control Panel's backup battery,
during an AC power failure, the display goes dark after 30
seconds regardless of this setting.
To set the display backlight time:
1 At the Home screen, tap Security.
2 At the Security screen, tap Menu.
3 At the Menu screen, tap Toolbox.
4 Enter a valid user code to gain access to the Toolbox.
5 At the Toolbox (1 of 3) screen, tap the  arrow.
6 At the Toolbox (2 of 3) screen, tap Backlight Time-out.
7 Choose one of the display backlight times and tap OK.

CLEANING THE TOUCH SCREEN

There is a special option for the Control Panel that enables
you to clean the touch screen display. The option disables
the touch screen for 30 seconds so the display can be
cleaned with a dry, soft cloth.
To disable the touch screen for cleaning:
1 At the Home screen, tap Security.
2 At the Security screen, tap Menu.
3
At the Menu screen, tap Toolbox.
4 Enter a valid user code to gain access to the Toolbox.
5 At the Toolbox (1 of 3) screen, tap the  arrow.
6 At the Toolbox (2 of 3) screen, tap clean screen.
NOTE: The Display Cleaning screen appears for 30
seconds. It shows the time remaining. The touch screen is
locked during this time. When the timer expires, the system
returns to the Toolbox screen.

SET DATE AND TIME

The Control Panel has a built-in clock and calendar. The
Home screen displays the time and date. The time and
date are also used for the system history and event logs
that store data on system events.
NOTE: During installation, your installer can set the
system to automatically adjust for daylight saving time if it's
observed in your location.
NOTE: The time and date are automatically set through the
cellular radio by the Central Station if your Control Panel
has a cellular radio installed.
32
System Toolbox
Copyright © 2019 Nortek Security & Control