Exit Delay Restart; Silent Control In Away Mode; Quick Exit In Away Mode; Auto Stay Mode - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide

Exit Delay Restart

The Exit Delay Restart option extends the Exit Delay one
time if you need to re-enter the premises. With the Exit
Delay Restart option, when you re-enter the premises after
you have left, but before the Exit Delay timer expires, the
Exit Delay timer restarts, giving you the full length of time to
leave again.
TIP: The Exit Delay Restart option only works once, each
time the system is armed.

Silent Control in Away Mode

Three options for silencing the beeps and announcements
are available when arming or disarming the system in Away
mode.
● On the Control Panel's Home and Security screens, a
Silent Control button is displayed.
● On the Arming screen, a Silent Exit check box is
displayed.
● On the Exit Delay screen, a Silence button is
displayed.
Selecting any of these options silences the Control Panel
beeps and announcements. When arming, selecting Silent
Control doubles the length of the Exit Delay.

Quick Exit in Away Mode

Quick Exit is only available when the panel is armed STAY.
When armed AWAY, the Quick Exit button is not displayed
on the Security screen.
TIP: If interior sensors are installed in the system in certain
areas, do not violate those sensors when using the Quick
Exit feature in Away mode.

Auto Stay Mode

The system may have been programmed by the installer
for Auto Stay mode. If this option is on and the system is
armed in Away mode, if an Exit/Entry Delay sensor is not
triggered before the Exit Delay expires (no one leaves the
premises), the system automatically arms in Stay mode
instead of Away mode.
NOTE: Quick options can be turned on or off by your
installer. Refer to "Installer Programmed Options", on
34, to see which options have been set for your system.

Arming to Away Mode

Use the Away mode to arm the system when everyone
will be leaving the home. The Away mode normally has
an entry delay so someone with a user code can re-enter
without causing an alarm. Interior and perimeter sensors
are armed in the Away mode.
1 Close all sensor-protected doors and windows before
arming.
2 Verify that the
illuminated blue, indicating that the system is Ready
to Arm. The Security button and Arm button on the
display will also be green when all perimeter sensors
are closed. If the
bar, an interior sensor is open. Make certain to close
the interior sensors or an alarm will occur.
3 To arm the system quietly without sounding any
announcements, tap the
the next steps:
● At the Arming screen check the Silent Exit box
Or
● During the Exit Delay, tap Silence
4 At the Security screen, or the Menu screen, tap Arm.
NOTE: If any perimeter door or window sensors are
open, the Bypass screen appears. Close all the sensors
displayed or tap Bypass All to force bypass the displayed
sensors.
NOTE: Bypassed sensors do not trigger an alarm.
To bypass sensors, enter a user code unless the installer
has set the system for Quick Bypass.
5 On the Arming screen, the Entry Delay check box
option can be used with Away mode.
● The system can be armed without an Entry Delay.
All perimeter doors trigger the alarm instantly. The
system has to be disarmed with a wireless key
page
fob. To arm with all exit/entry perimeter doors as
instant, clear the Entry Delay check box.
6 Tap Away.
To arm the system, enter a user code if your installer
has turned off the system's Quick Arming feature.
14
Burglary Protection
button on the Control Panel is
icon is displayed on the status
button before performing
Copyright © 2019 Nortek Security & Control