Quick Arming; Quick Bypass; Quick Exit; Auto Un-Bypass - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide

Quick Arming

Quick Arming allows you to arm your system without having
to enter a user code. When you tap the Stay or Away
button, the system will start to arm without requesting a
user code.
● Off
● On

Quick Bypass

Normally sensors that are open at the time the system
is armed will require force bypassing by entering your
user code. The system can be set so a user code is not
required to bypass open sensors when the system is
armed.
● Off
● On

Quick Exit

The Quick Exit option allows you to start the Exit Delay
while the system is armed Stay. This allows you to leave
the premises without having to disarm and rearm the
system. When the Quick Exit option is on, a Quick Exit
button will display on the Security screen. Tap the button to
start the Exit Delay.
After Quick Exit, the system will fully re-arm in the mode
that it was in before (Stay).
● Off
● On

Auto Un-bypass

Normally, sensors manually bypassed with the User
Toolbox will automatically have their bypasses removed
when the system is disarmed. The system can be set
so sensors that have been manually bypassed will stay
bypassed until the bypass is manually removed.
● Off
● On

Auto Stay

The Auto Stay option will change the arming mode if no
one exits after arming the system in Away mode. When the
system is armed in the Away mode the Exit Delay will begin.
With the Auto Stay option on, if a designated exit/entry door
does not open and close during the Exit Delay, the system
will arm in the Stay mode instead of the Away mode.
● Off
● On

Key Fob Sound

The system can be set so when it is armed or disarmed by
a wireless key fob, a beep will sound through the internal
and external sounders to indicate that the key fob's signal
was received. This helps in installations where the Control
Panel is not visible or there are no other system status
indications at the key fob's location.
● Off
● On

Key Fob Disarm After Sound

The system can be set so that when it is disarmed with
a wireless key fob after an alarm has occurred, a special
series of beeps will sound through the internal and external
sounders. This option serves as an alert to warn you to
approach the premises with caution as an intruder may still
be present.
● Off
● On

Key Fob Options

The installer selects which options are enabled for each
key fob (1-8) used with the system. Refer to the table below
for the options selected for your key fobs:
Option
Arm without Exit Delay
Allow key fob disarming
Auxiliary Alarm
Audible Alarm
Silent Panic Alarm
Fire Alarm
Emergency Keys Disabled
Key Fob Arming Bypass Options
Option
Auto-bypass all open perimeter
sensors and un-bypass a sensor if
closed while the system is armed
Auto-bypass open perimeter sensors
permanently while armed
Allow key fob arming only when all
perimeter sensors are closed
35
System Toolbox
1 2 3 4 5 6 7 8
All Key Fobs
Copyright © 2019 Nortek Security & Control