Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: The wood chip pan and door get very hot. Avoid handling them while in use.
Always wear protective oven mitts when handling hot components.
• Cooking Tip – Flavoring wood:
• Small wood chips work best inside the wood chip pan.
• Use dry hardwoods such as hickory, pecan, apple, cherry, or mesquite.
• Most fruit or nut tree woods produce excellent smoke flavoring.
• Do not use resinous woods such as pine or plywood. These usually produce unpleasant
flavoring.
• Let your taste be your guide – experiment with different types and quantities of wood
chunks, chips, or sticks. You can even mix woods.
• To produce more smoke and to prevent fast burning, pre-soak the wood chips in a
separate pan of water for at least 20 minutes, or wrap the chips in perforated aluminum
foil.
• Most smoke flavoring occurs within the first hour of cooking. Adding wood chips after
the first hour is typically not necessary unless extra smoke flavoring is desired.
I I G G N N I I T T E E R R L L I I G G H H T T I I N N G G S S Y Y S S T T E E M M : :
1. Check all connections for leaks using the "soapy water" test as explained on page 8.
2. Open the smoker cabinet doors.
3. Check for any blockage to the burner. Remove any foreign objects or matter.
4. Be sure the burner control knob is in the "OFF" position.
5. Open the LP cylinder valve by turning counter-clockwise.
6. To light unit with the igniter, push and hold down control knob and SLOWLY (2 to 3
seconds) turn to ignite. You should hear the igniter click. This step may need to be
repeated 2-3 times to light burner. If ignition does NOT occur in 5 seconds, turn control
knob to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
7. Once the burner is lit, then close the doors to allow heat to accumulate.
M M A A T T C C H H L L I I G G H H T T I I N N G G : :
1. Repeat steps 1 thru 5 of the Igniter Lighting System above.
2. Remove the Wood Chip Pan. Light a paper match and drop it into the burn chamber,
making sure it falls next to the burner. Quickly turn the control knob to the light position.
If the burner does not light within 4 or 5 seconds, turn the control knob off, wait 5
minutes for gas to clear, and repeat the process.
L L I I G G H H T T I I N N G G P P R R O O C C E E D D U U R R E E S S
10
Publicidad
