Operation Start-Up; Shift To Booster Or Fader Mode (During Voltage Variations In The Ac-Input Power) - MGE UPS Systems Pulsar Evolution 2200 Manual De Instalación Y Usuario

3. Operation
3.1 Start-up
If button 15 or LED 16 are not ON or if LED 17 is ON, there is a fault (see section 4.1).
Note: The battery is charged as soon as the UPS is connected to the AC-power source, even if button 15 is in the OFF
position.
3.2 Shift to booster or fader mode
(during voltage variations in the AC-input power)
Page 16 -
34007115EN/AA
1 2
%
%
1 2
%
%
Press the ON / OFF button 15 .
The buzzer beeps and all the LEDs come ON.
The buzzer beeps twice during the self-test, then button 15 remains
15
ON, indicating that the outlets are supplied with power.
- AC power is present: Only button 15 is ON. The protected
16
equipment is supplied by the AC-power source.
17
- AC power is absent: Button 15 and LED 16 are ON. The protected
equipment is supplied by the UPS, operating on battery power.
All the connected equipment is supplied with power.
The booster and fader functions maintain the output voltage supplied by
the UPS within close tolerances around the rated value even if
significant voltage variations occur in the AC-input power. This avoids
calling on battery power.
The values defining the voltage range may be set using the UPS Driver
software.
During operation in booster or fader mode, LED 21 is ON, signalling a
significant voltage variation in the AC-input power.
21