Before First Use - pellenc FIXION Guia Del Usuario

DESCRIPTION AND TECHNICAL CHARACTERISTICS
DESCRIPTION AND TECHNICAL CHARACTERISTICS
Max. tying capacity
Tying tool power voltage*
Charger power voltage
Charger average power
NiMH battery capacity
Charging time
Tying capacity (without charge)*
Tie material total length
Corresponding number of ties
Tying tool weight
Weight of carried tool (belt unit)*
*(with specified battery)
Total vibration values (triax vector sum) determined in accordance
with EN 60745-1.
(Uncertainty K=1.5 m/s²)
Noise value measured according to the standard EN 60745-1
Sound power level measured
(Uncertainty K=3 dB)
Level of acoustic pressure at the work station measured
(Uncertainty K=3 dB)

BEFORE FIRST USE

- Take the belt unit and tying tool out of the case.
- Rotate reel holder 10, placed under battery pack 12, so that the tie outlet is located on the right or left-
hand side, depending on whether you are right or left handed.
- Set the belt length using the two buckles 15.
ADAPTATION FOR BATTERY P2000
From September 1996 (serial no. 2900001/U), there is no special procedure required for use of the FIXION
with the P2000 battery.
- Check that switch 11 is definitely in the "0" position.
- Install the P2000 battery, instead of the special battery 12.
- Your tool is ready for use.
refer to charger operating instructions
200 m/reel approx. (656 ft)
9
25 mm (1 in)
14,4 V
5 W
3,0 Ah
12 hours
9,000 to 12,000 ties
1,550 ties approx.
900 g (2 lbs)
2 kg (4,4 lbs)
a <2.5 m/s² max.
h
L = 81 dB maximum
WA
L = 70 dB maximum
pA