Preparation For Installing The Unit; Environment; Environmental Conditions - Ingeteam INGECON EMS Manual De Instalacion Y Uso

Ingeteam

6. Preparation for installing the unit

When deciding the location of the unit and planning your installation, you must follow a set of guidelines based on
the specifications of the unit. These guidelines are summarized in this chapter.

6.1. Environment

• These units can be installed indoors and outdoors.
• Place the units in a place which is accessible for installation and maintenance work and which permits
use of the keyboard and the reading of the front indicator LEDs.
• Avoid corrosive environments that may affect the proper operation of the inverter.
• Never place any object on top of the unit.
• Do not expose the inverters to direct sunlight.
• Do not install the units in inhabited rooms. The inverter produces a slight buzz when in operation.
Maintain a 30 cm area obstacle-free around the side, upper, lower and front walls.

6.2. Environmental conditions

Environmental operating conditions indicated in section "2.9. Specification table" must be taken into account
when choosing the location of the unit.
The surrounding atmosphere must be clean and at temperatures above 40 ºC, the relative humidity must be
between 4% and 50%. Higher percentages of relative humidity up to 95% are tolerated at temperatures below
30 ºC .
Take into account that moderate condensation may occasionally occur as a consequence of temperature variations.
For this reason, apart from the unit's own protection, it is necessary to monitor these units once they have been
started up on sites where the conditions described above are not expected to be present.
In the event of condensation, never apply voltage to the unit.
16
Preparation for installing the unit
ABP2011IQM01_ - Installation and Operation Manual