Metrohm 758 KFD Titrino Instrucciones Para El Uso página 104

3.2 Remote control commands
100
In place of "RSX", a result name may be entered (.TextRS). This name is out-
putted in the report full, short, scalc full and scalc srt. It is used for the result
and the corresponding mean value.
The limit control for results can also be activated. If a result is out of limit, a
message appears in the result report, E196 is sent, and output line L13 can
be set.
3.2.2.6. Mode.Def.SiloCalc.Assign.C24
Mode.Def.SiloCalc.Assign.C25
Mode.Def.SiloCalc.MatchId
.Assign.C2X: Assignment to store results in the silo as C2X.
.MatchId: Indication which sample identification(s) have to match so that
the results can be combined.
3.2.2.7. Mode.Def.ComVar.C30
Mode.Def.ComVar.C31
etc., up to .C39
Assignment of common variables.
The values of the common variables are to be found in &Config.ComVar. They
can be viewed and entered there, see 3.2.2.80.
3.2.2.8. Mode.Def.Report.Assign1
Mode.Def.Report.Assign2
SET, MEAS: param, calib, full, short, mplist, curve, scalc full,
scalc srt, calc, ff
KFT: param, full, short, mplist, curve, scalc full, scalc srt, calc, ff
CAL: param, calib, full, short, scalc full, scalc srt, calc, ff
TIP: param, full, short, scalc full, scalc srt, calc, ff
Definition of the report sequence, which is outputted automatically at the end
of the determination. Entries of more than one block have to be separated with
";".
.Assign1: Output to COM1 of the Titrino. Identical for COM2.
3.2.2.9. Mode.Def.Mean.1.Assign
Mode.Def.Mean.2.Assign
etc., up to .9
Assignment of the statistics calculations. Valid assignments are a requirement
for statistics calculations. In addition, the statistics calculation must be swit-
ched on, see 3.2.2.26. Rules for statistics calculations see page 46.
3.2.2.10. Mode.Def.TempVar.C70
etc. up to .C79
Assignment of temporary variables in a submethod for calculations in TIP.
RSX, EPX, CXX
RSX, EPX, CXX
id1, id1&2, all, OFF
RSX, MNX, EPX, CXX
RS1, RSX, EPX, CXX
RSX, EPX, CXX
758 KFD Titrino