Metrohm 758 KFD Titrino Instrucciones Para El Uso página 127

758 KFD Titrino
3.2.2.121. Assembly.Bur.Prep
Starts the function "preparation". The parameters are under the function
&Config.DosPrep, see 3.2.2.84 up to 3.2.2.91.
3.2.2.122. Assembly.Bur.Rates.Forward.Selected
Assembly.Bur.Rates.Forward.Digital
Assembly.Bur.Rates.Reverse.Selected
Assembly.Bur.Rates.Reverse.Digital
Expel and aspirating rate.
Digital or analog control. With digital control, the inputted value applies (in
mL/min). "max." means maximum possible rate with the Exchange Unit in
current use.
Analog means rate control with the analog potentiometer on Titrino.
3.2.2.123. Assembly.Bur.Fill
$G starts the 'FILL' mode of the burette function.
3.2.2.124. Assembly.Bur.ModeDis
Assembly.Bur.ModeDis.Selected
Assembly.Bur.ModeDis.V
Assembly.Bur.ModeDis.Time
Assembly.Bur.ModeDis.VStop
Assembly.Bur.ModeDis.AutoFill
Dispensing mode with parameters. The dispensing mode can only be started
and stopped via the RS Control. During a running dosification, no method can
be started at the Titrino.
.Selected: Dispensing of volume increments or during a preset time.
.Volume, .Time: Size of the volume increments or entry of time.
.VStop: Limit volume for the dispensing.
.AutoFill: ON means automatic filling after every dispensing.
3.2.2.125. Assembly.Meas.Status
Assembly.Meas.MeasInput
Assembly.Meas.Ipol
Assembly.Meas.Upol
Measurement in assembly. The measuring function can only be started via RS
Control. When the measuring function is switched on, no method can be
started at the Titrino.
.Input: Selection of the potentiometric measuring input 1, 2, diff., polar-
ized electrodes or temperature.
.Ipol: Polarization current in µA.
.Upol: Polarization potential in mV, entry in steps of 10 mV.
3.2 Remote control commands
$G, $S, $H, $C
digital, analog
0...150, max.
digital, analog
0...150, max.
$G, $S, $H, $C
volume, time
0.0001...0.1...9999
0.25...1...86400
0.0001...9999, OFF
1, 2, Diff., Ipol, Upol, Temp
±127...1...+127
±1270...400...+1270
$G, $H, $C
ON, OFF
ON, OFF
123