Metrohm 758 KFD Titrino Instrucciones Para El Uso página 118

3.2 Remote control commands
114
3.2.2.87. Config.DosPrep.DX(.Dosimat).DosRate
Config.DosPrep.DX(.Dosimat).FillRate
Dosing and filling rate in mL/in for the preparation. Start sequence see
3.2.2.121.
3.2.2.88. Config.DosPrep.DX.Select
Selection of buret type. Start sequence see 3.2.2.121.
3.2.2.89. Config.DosPrep.DX.Dosino.Outlet
Place where the liquid of the preparation is expelled. Start sequence see
3.2.2.121.
tip: To the tip.
flask: Back to the flask.
3.2.2.90. Config.DosPrep.DX.Dosino.DosTubing.Length
Config.DosPrep.DX.Dosino.DosTubing.Diameter
Config.DosPrep.DX.Dosino.AspirTubing.Length
Config.DosPrep.DX.Dosino.AspirTubing.Diameter
.DosTubing: Dosing tube. Length in cm, diameter in mm.
.AspirTubing: Aspiration tube. Length in cm, diameter in mm.
Start sequence see 3.2.2.121.
3.2.2.91. Config.DosPrep.DX.Dosino.DosRate
Config.DosPrep.DX.Dosino.FillRate
Dosing and filling rate in mL/min for preparation. Start sequence see
3.2.2.121.
3.2.2.92. SmplData.Status
On/off switching of silo memory. When the silo memory is switched on, the
sample data are fetched from the lowest valid silo line.
3.2.2.93. SmplData.OFFSilo.Id1
SmplData.OFFSilo.Id2
SmplData.OFFSilo.Id3
SmplData.OFFSilo.ValSmpl
SmplData.OFFSilo.UnitSmpl
Current sample data.
The identifications Id1...Id3 can be used in formulas as sample-specific calcu-
lation constants C21...C23.
If "no unit" is desired for the unit of the sample size, the blank string must be
entered.
0.01...150, max.
0.01...150, max.
Dosimat, Dosino
tip, flask
1...40...999.9
0.1...2...9.9
1...25...999.9
0.1...2...9.9
0.01...150, max.
0.01...150, max.
ON, OFF
up to 8 ASCII characters
up to 8 ASCII characters
up to 8 ASCII characters
6-digits, sign and decimal point
up to 5 ASCII characters
758 KFD Titrino