CYBEX gold SIRONA S Manual Del Propietário página 71

INSTALLING CHILD RESTRAINT WITH LAP/SHOULDER BELT
(PREFERRED METHOD)
10. Grab Base near belt path and pull side to
10
side and front to back to make sure Base is
installed tightly. Base should not move more
than 2.5 cm (1 in) side to side or front to back
at the Belt Path on the Child Restraint.
If Base moves too much, open Belt Tensioner,
tension vehicle belt a little more and try
again. After this, if Base still moves too much,
you may need to try a different vehicle seat
location or installation method, or both.
In most vehicles, you can switch shoulder
belt retractor into locking mode by pulling out
shoulder belt all the way and letting it rewind into
the retractor. Pull on shoulder belt to make sure
it is locking.
NEVER install this Child Restraint using a
non-locking vehicle lap/shoulder belt.
NOTE: Refer to your vehicle Owner's Manual
for information.
71