Starrett PKG08762 Manual De Usuario página 10

ENGLISH
USING A SCRIBER
11. The special scriber furnished with the height gage can be mounted using the
scriber clamp.
12. Allow the scriber to contact the surface that will be your zero reference.
13. Operation of the height gage is the same as noted above in "To Establish a Zero
Reference Using an Indicator" and below "Height Measurement".
NOTE: Use of the scriber to contact work surfaces depends on the ability of the operator to
"feel" the contact surface without exerting excess pressure on the surface with the scriber.
HEIGHT MEASUREMENT
14. Loosen the lock on the gage slide and the fine-adjust, and then move the gage into
position so that the indicator contact is directly over the surface to be measured.
15. Using the fine adjustment mechanism, move the slide until the indicator reads zero.
16. The display will show the exact dimension of the surface or feature being measured
with reference to the zero position or datum you set up.
10 PKG08762-UM3754