GASPARDO SARA Empleo Y Mantenimiento página 38

ENGLISH
33) For transport, adjust and fasten the lateral lifting arm chains
of the tractor; check that the seed and fertilizer hopper covers
are closed properly; lock the hy-draulic lifting control lever;
hook the seeders unit following the instructions referring on
page 47.
34) Road movements must be per-formed with all tanks empty.
35) For displacements beyond the work area, the equipment
must be placed in the transportation position. This also
involves the necessity of disconnecting any hydraulic
connection to the tractor.
36) Upon request the Manufacturer will supply supports and
tables for signaling of dimensions. 37) When the dimensions
of carried or partially-carried equipment conceal the tractor's
signalling and lighting devices, these must also be installed
on the equip-ment itself, in conformity with regulations of the
highway code of the country involved. When in operation make
sure that the lighting system is in perfect work-ing order.
Cardan shaft
38) The equipment installed can only be controlled by means of
the Cardan shaft complete with the necessary overload safety
devi-ces and guards fastened with the appropriate chain.
39) Only the Cardan shaft supplied by the Manufacturer must be
used.
40) The engine must not be running when installing and removing
the Cardan shaft.
41) Care must be taken regarding the safety and correct
assembly of the Cardan shaft.
42) Use the chain provided to stop the Cardan shaft from rotating.
43) Always check carefully that the Cardan shaft guard is always
in position, both during transporta-tion and operation.
44) Frequently and set intervals check the Cardan shaft guard, it
must always be in excellent condition.
45) Before engaging the power take-off, check that the set rpm
corresponds to that indicated by the sticker on the equipment.
46) Before inserting the power take-off, make sure that there are
no people or animals nearby and that the rpm selected
corre-sponds to that permitted. Never exceed the maximum
admissible speed.
fig. 6
38
USE AND MAINTENANCE
47) Watch out for the rotating univer-sal joint.
48) Do not insert the power take-off with the engine off or synchro-
nized with the wheels.
49) Always disconnect the power take-off when the Cardan shaft
is at too wide an angle (never more than 10° - Fig. 6) and
when it is not being used.
50) Only clean and grease the Cardan shaft when the power
take-off is disconnected, the engine is off, the hand brake
pulled and the key removed.
51) When not in use, place the Cardan shaft on the support pro-
vided for it.
52) After having dismantled the Cardan shaft, place the protec-
tive cover on the power take-off shaft again.
Maintenance in safety
Durante le operazioni di lavoro e manutenzione, utilizzare gli
idonei dispositivi di protezione individuale (es.):
Overalls
53) Do not proceed with maintenance and cleaning if the power
take-off has not been disconnected first, the engine power
off, the hand brake pulled and the tractor blocked with a
wooden block or stone of the right size under the wheels.
54) Periodically check that the bolts and nuts are tight, and if
necessary tighten them again. For this it would be advisable
to use a torque wrench, respecting the values of 53 Nm for
M10 bolts, resistance class 8.8, and 150 Nm for M14 bolts
resistance class 8.8 (Table.1)
55) During assembling, maintenance, cleaning, fitting, etc., with
the seeding machine raised, place adequate supports under
the equipment as a precaution.
56) The spare parts must correspond to the manufacturer's spe-
cifica-tions. Use only original spares.
g
Gloves Shoes Goggles Helmets
Table 1
cod. G19502521