Secureguard - Britax PARKWAY SGL Guia Del Usuario

Using the Booster Seat

SecureGuard

BRITAX recommends using the
SecureGuard to achieve best vehicle
seat belt placement. The SecureGuard
clip should hold the lap part of the
vehicle seat belt in place.
The SecureGuard clip should be
adjusted to keep the lap part of the
vehicle seat belt positioned low across
your child's upper thighs (Fig. A). Ensure the bottom edge of
the SecureGuard clip is level with your child's upper thighs;
however, the clip itself should not press into your child's upper
thighs.
The lap part of the vehicle seat belt must not rest
IMPORTANT:
on the child's abdomen.
Adjusting SecureGuard Fit
To Remove the SecureGuard Clip:
Remove the base cover. (Fig. B)
1
Locate the SecureGuard adjuster
2
and rotate adjuster strap 90 degrees
(Fig. B).
Slide the SecureGuard adjuster
3
through slot and pull through the
opening and away from the base
(Fig. C).
20
a
B
C
To Shorten:
Feed the webbing through the
1
SecureGuard adjuster (Fig. D).
Pull the end of the SecureGuard
2
adjuster webbing to tighten.
To Lengthen:
Feed the end of the SecureGuard
1
adjuster webbing through the
SecureGuard adjuster (Fig. E).
Pull the webbing to remove slack from
2
the SecureGuard adjuster.
Move the SecureGuard clip to the
3
center of the SecureGuard webbing
(Fig. F).
The lower edge of the SecureGuard clip
should be level with the child's upper
thighs once the child has been secured
in the booster seat.
To Reattach the SecureGuard Clip:
Reverse the directions on page 20 to install the SecureGuard
clip back into the base of the seat.
Using the Booster Seat
D
E
F
21