Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. Installlanyardusingexistingself-tappingscrew.See Figure4.
2.
Fromthe outside,insertthe bolts throughthe hourglassspacers
and the holesof the pivot bracket.Securewith theflange lock
nuts.See Figure6.
Figure 4
NOTE: Insertself-tappingscrewthroughhole in lanyardand downinto
the samehole that it was removed from.
Position
Drive Control
levers
Thedrivecontrol leversof the ridingmowerare loweredfor shipping
purposes.Usingthe hardwarefoundin the manualbag,the control
leversmustbe repositioned to operatethe ridingmower.To reposition
the controlleversfor operation,proceedas follows:
1.
Lift and swingthecontrol leversup into theoperatingposition.
See Fig. 5.
r
Control Lever Moved
inward and in Neutral
Figure 6
3.
Refer to"Adjusting t heDriveControl Levers" i n theService and Mainte-
nancesection forinstructions o nthefinal a djustment ofthelevers.
Connecting
the Battery
Cables
Batteryposts,terminals,and relatedaccessoriescontainlead and
lead compounds, c hemicalsknownto the Stateof Californiato cause
cancerand reproductive harm.Wash handsafter handling.
Whenattachingbatterycables,alwaysconnectthe POSITIVE(Red)
wireto its terminalfirst, followedby the NEGATIVE (Black)wire.
Forshippingreasons,bothbatterycableson yourequipmentmay
havebeen left disconnected from the terminalsat the factory.To
connectthe batterycables,proceedas follows:
NOTE:Thepositivebatteryterminalis markedPos. (+).The negative
batteryterminalis markedNeg.(-).
NOTE:If the positivebatterycable is alreadyattached,skip aheadto
step2.
Figure5
J
10
Publicidad
Tabla de contenido
